Customer Message
I decided to choose your product versus other due to the choice of sizes and accessories. I am a strong woman but I had reservations about being able to bend this steel for corners. None of my corners are 45 or 90 degrees. Needless to say it was all I could do to bend them and even still they ended up wonky which means the start/stop pieces don’t match up. These corners are mostly hidden but I’m still a bit disappointed with the results and your advertising. Perhaps there should be better instructions for getting better results. Using a board isn’t helpful when it is impossible to bend a corner on a short end
Customer Story
Cor-Ten Walkway Border, Tough Custom Corners
Cheryl chose Edge Right for the range of sizes and accessories and installed 6-inch 16 gauge Cor-Ten hammer-in strips with start and finish pieces along her front walk. The straight runs look clean, but bending tight, non-45 or 90 degree corners was very difficult and the start and finish pieces did not align. She recommends clearer corner-bending guidance, especially for short ends, to help DIY users get better results.
Media
4
Products
4
Customer Message
I decided to choose your product versus other due to the choice of sizes and accessories. I am a strong woman but I had reservations about being able to bend this steel for corners. None of my corners are 45 or 90 degrees. Needless to say it was all I could do to bend them and even still they ended up wonky which means the start/stop pieces don’t match up. These corners are mostly hidden but I’m still a bit disappointed with the results and your advertising. Perhaps there should be better instructions for getting better results. Using a board isn’t helpful when it is impossible to bend a corner on a short end
Products featured
The products connected to this customer story.
